Hello (again)....

Aside from what I see in the "Implementation Guide", is there anything I need to know about 3com cards and Ghost??

When I attempt to pull an image down to a Dell OptiPlex GX150....it takes about a half an hour to complete....when I disable the 3com (which is onbaord), and stick in an Intel Pro 100 card.....it takes just over 2 minutes (2:07) to complete.....ports are good...switches and routers are good.....next to NO traffic on the server.....7200 rpm Seagate Barracuda HDD....256mb RAM......


I want to stay away from RIS boot disk if I can....


Any suggestions???